User guide

87
Instrument Calibration
Instrument calibration will allow you to calibrate the various
instruments and set the desired warning levels.
Calibration mode can be entered from the run screen as
long as you do not have any airspeed from the following
menu:
[CHECK] -> [MAINT] -> [ADMIN] -> [CALIB] Hold for 2 seconds
A list of instruments will appear. You scroll through the list
by using the [PREV] and [NEXT] buttons. There are
multiple pages of instruments.
To calibrate an instrument press the [SELECT] button
while the cursor is on the desired instrument. On the Right
of your screen a calibration list will appear.
On the top right a number will appear. This is the digital value read by the sensor you are calibrating. This
value will change if the condition the sensor is reading changes.
Below this number there will be a list of calibration data. Use [NEXT] and [PREV] buttons to scroll through
the calibration list.
To adjust any of the warning values make sure the cursor is on the desired one and twist the knob until the
value you desire is displayed.
When you have calibrated the instrument you can return to the main instrument list by pressing the
[RETURN] button.
The following parameters can be set:
Max
The instrument displayed value at the top of the gauge
Red High At
The instrument displayed value when the needle turns red at the top of the gauge. You can set this
parameter to the Max value if you do not want a top red band.
Yellow High At
The instrument displayed value when the needle turns yellow at the top of the gauge. You can set this
parameter to the Max value if you do not want a top yellow band.
Yellow Low At
The instrument displayed value when the needle turns yellow at the bottom of the gauge. You can set this
parameter to the Min value if you do not want a bottom yellow band.
Red Low At
The instrument displayed value when the needle turns red at the bottom of the gauge. You can set this
parameter to the Min value if you do not want a bottom yellow band.
Minimum
The instrument displayed value at the bottom of the gauge
Audio On/Off
Turns on or off the audio warning feature.
Instrument On/Off
Turns on or off the entire instrument.