User's Manual

AFG ASIA ENGINEERING CO.LTD.
65/12 M.10 T.Tonpao A.Sankumpang
Chiangmai, Thailand 50130
Tel: [phone]
Fax: [phone]
Page 8
PR100
User manual
Released
Ref. - (PR100 readers) Rev. 1_01 2008-03-13
Picture 3.3.2 “ISO-6B WRITE DATA(H)” mode
User can type in 1 – 32 bytes data from the keyboard on the PR100 RFID reader.
Trip: if user wants to type in A,B,C in heximal, just repeat pressing the “2” button. If user wants
to type in D,E,F in heximal, just repeat pressing the “3” button.
Note: user must enter the heximal data correctly. For example, the reader does not allow writing
the heximal data which has wrong data length such as 0102030 (3 and half bytes), the reader
will show error “WRONG LENGTH” on the display when user attempts to write it.
When user finishes typing in the data, point the reader to an ISO18000/6B tag ,press and hold
the “Trigger” button to write the data into the tag until the display shows “PASS”. When it
finishes writing the display will show “PASSED” and the buzzer will beep.
Picture 3.3.3 writing success
If user wants to write data in ASCII mode, just press the “DISPLAY” button.