User's Manual

AFG ASIA ENGINEERING CO.LTD.
65/12 M.10 T.Tonpao A.Sankumpang
Chiangmai, Thailand 50130
Tel: [phone]
Fax: [phone]
Page 10
PR100
User manual
Released
Ref. - (PR100 readers) Rev. 1_01 2008-03-13
“EPC-G2 READ ID(H)” -> “EPC-G2 READ EPC” -> “EPC-G2 READ DATA(H)”
-> “EPC-G2 READ ID(A)” -> “EPC-G2 READ TID(H)” ->“EPC-G2 READ RESV(H)”
The PR100 RFID reader allows user to write EPC(ID) and DATA into ISO18000/6B(EPC Class1
Gen2) tags. When user want to write EPC(ID) or DATA, just press the “TAG TYPE” button to
select “EPC-G2” mode and then press “OPERATION” to select “WRITE ID(H)” mode and then
press the “DISPLAY” button.
3.5 Menu
User can change the data length, start address for reading/writing ISO18000/6B and start
address for reading/writing ISO18000/6C by pressing the “MENU” button. If user repeats
pressing the “MENU” button, the reader will go to the sequence below:
“SET DATALENGHT” -> “SET START ADDRESS FOR ISO-6B” -> ‘“SET START ADDRESS
FOR EPC-G2”
To change the values, just press the “LEFT” or “RIGHT” button.
To go back to reading/writing mode press “OK” or “CLEAR”
Picture 3.6.1 the position of the “LEFT” and “RIGHT” button.