User's Manual

AFG ASIA ENGINEERING CO.LTD.
65/12 M.10 T.Tonpao A.Sankumpang
Chiangmai, Thailand 50130
Tel: [phone]
Fax: [phone]
Page 13
PR100
User manual
Released
Ref. - (PR100 readers) Rev. 1_01 2008-03-13
4. FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this equipment.
(Example - use only shielded interface cables when connecting to computer or peripheral
devices).
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
FCC Radiation Exposure Statement:
(if mobile device (generally 20 cm distance) is applicable, MPE calculation)
“This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. The antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter”.
(if portable device is applicable (SAR))
“This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. SAR has been evaluated with a laptop as host and the maximum SAR value
reported is 0.76 W/kg. This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter”.
(also important for LAN is the following statement; may be included in manual or separate
letter))
“This equipment marketed in USA is restricted by firmware to only operate on 2.4 GHz channel
1-11”.