User's Manual

30
Set Data Length (23)
Description: Get the configuration of the data length that the reader will read out from
the tag memory where starts at the Start Address (3.9 page 16) when the reader was set
Read Bank to:
• Read block data from the specific address
• Read Reserve bank at the specific address
• Read TID bank at the specific address
• Read User Memory bank at the specific address
• Read User Memory bank at the specific address
Type: RFID protocol configuration command with Parameter.
Transmits from PC to PR110 UHF RFID READER:
Command Number (2
chars)
Parameter (0 char)
Carriage return,
<CR>(1char)
23
-
<CR>
Where:
“23” is the command number.
Returns from PR110 UHF RFID READER:
Command Number (2
chars)
Parameter (2 chars) Carriage return,
<CR>(1char)
23 08 <CR>
Where:
“23” is the echo of the command number.
“08” is the data length.