User's Manual

Getting Start
Wake Up Reader
Press “POWER” button to wake up the reader from the sleep mode.
Change Reading/Writing Mode
Press “MODE” button to change the reading/writing mode between “READ” and
“WRITE”.
Change Reading/Writing Memory Bank
Press “DISPLAY” button to change the reading/writing memory bank.
If the reading/write tags type is in “EPC Class1 Gen2”, user can select reading/writing
memory bank as the list below:
• EPC – to read/write the EPC number with anti-collision algorithm.
• ACCESS/KILL – to read/write access or kill code (memory bank 00) from the
specific start address and data length.
• UII/EPC – to read/write UII (memory bank 01) from the specific start
address and data length.
• TID – to read/write TID (memory bank 02) from the specific start address
and data length.
• USER – to read/write USER (memory bank 03) from the specific start
address and data length.
Note: Please check again the specification of the tag that you are attempting to
read/write whether it supports reading/writing all of the banks.
Change Reading/Writing Memory Offset
Press “USER” button to change the reading/writing memory offset. User can set the new
offset by changing the start address and data length.