Operator`s manual

a d v a n c e d i l l u m i n a t i o n . c o m

P u l s a r 7 1 0 M a n u a l

Appendix C: Activate Trigger Pass Through

1. Disconnect all input and output cable connections from the Pulsar

710.

2. Remove the four retaining screws and gently lift the cover from the

housing, taking care to clear the power switch.

Note: ESD procedures should be followed while the cover is removed.

Itisrecommendedtousesmalltools,notngers,tomakeJumper

or Switch changes.

3. Switch S1 and Jumper J13 are used for these alternate trigger

congurations.Figure14showsthelocationofS1andJ13.

4. Place J13 so that pins 2 and 3 are shunted. (Factory Default)

5. To pass trigger 1 through and output it on Pin 4 (trigger 3), place POS

1 switch to “ON”.

6. To pass trigger 2 through and output it on Pin 5 (trigger 4), place POS

2 switch to “ON”.

7. POS 3 switch should be “OFF”.

8. POS 4 switch can be either “ON” or “OFF” depending whether you

need trigger 1 to be “sourcing” or “sinking”.

Figure 14: Pulsar 710 PCB