Service manual

24 Using Your Gateway Solo™ 9100 Multimedia Notebook
4. Pull the CD-ROM/Diskette disk combination drive module straight
out and away from your notebook, and release the latch.
5. Install the correct faceplate on the second battery. For details, see the
instructions that come with the second battery.
6. Turn the battery module over. (Your notebook was turned over, so the
module being installed must be turned over as well.)
7. Firmly push the module straight into the bay until the latch “clicks”
into place. If you don’t hear the “click” try it firmly again, making sure
it “clicks.”
8. Restart your system.
Note:
Anytime you replace a
module you must restart
your system for the module
to work. The restart has to
occur after the module is
correctly seated.