Service manual

48 Using Your Gateway Solo™ 9100 Multimedia Notebook
Using Standby mode in Windows 98
Windows98 uses Standby mode. When in Standby mode, your notebook
enters a sleep state. Cutting off power to most devices except memory.
The following table shows how to change the system modes in
Windows98.
Windows 95 and Windows NT
To modify your power management settings in Windows95 and
WindowsNT, you need to go into the BIOS program to change the power
management settings. See “Using the Power Menu” on Page 50 for more
information on these settings and how to modify them.
Using Suspend mode in Windows 95 and Windows NT
Windows 95 and Windows NT use Suspend mode. When in Suspend
mode, your notebook enters a sleep state according to the power
management settings. Suspend mode cuts off power from most devices
except memory.
If your
notebook
is...
...and you
want to...
...then do this:
Off Start up Press the power button
On Standby Click Start, Shut Down, Standby, then
click OK.
- OR -
Press
FN+F4
In Standby
mode
Resume
power
Press the power button briefly
On Shut down Click Start, Shut Down, click Shut Down
again, then click OK.