Installation Instructions

MAINTENANCE
115
The technical materials and information contained in this document are strictly confidential and the exclusive property of Advanced Microwave Engineering s.r.l.
These materials and information are intended solely for the purpose designated and may not be used otherwise.
It is not permitted to disclose or reproduce them in whole or in part without express written permission.
Device Description Possible solution
CPU
Does not turn on
Check the power supply; if it is higher than 30V, the CPU goes
into protection mode to avoid any damage.
Check the fuse inside the CPU.
If the error does not disappear, we recommend contacting the support
centre.
The stand-by function does not
work
Check the V
Q
. signal
If the error does not disappear, we recommend contacting the support
centre.
It restarts repeatedly If the system never makes a complete start, contact the support centre.
DISPLAY
The screen is black
Check the connection of the display connector to the CPU.
Disconnect and connect again the CPU power supply; if no
sound is heard, check the CPU power supply.
If the error does not disappear, we recommend contacting the support
centre.
The screen is white
Check the connection of the display connector to the CPU.
Disconnect and connect again the CPU power supply.
Check if the power supply line of the CPU has sufficient
current (1.5A).
If the error does not disappear, we recommend contacting the support
centre.
Touchscreen does not work
Disconnect and connect again the display connector to the
CPU.
Restart the system by disconnecting and connecting again
the CPU power supply.
If the error does not disappear, we recommend contacting the support
centre.
No sound
Check the volume from the system settings.
If the error does not disappear, we recommend contacting the support
centre.
TAG Not detected by the system
Check the battery of the TAG.
If the CheckPoint is present, check the status of the TAG on
this device.
Check the configuration of the sensors, in particular the
power set.
Check if the RF antenna is correctly installed and
connected to the HUB (see section 8.3.4).
If the Filter Sens module is present, check its configuration,
and check that the tag is not inhibited beyond the driver's
cabin limit.
If the error does not disappear, we recommend contacting the support
centre.
GPS Video icon is always in red
Check the position of the external antenna.
It must be facing the sky and not be shielded by metal parts.
Check the connection to the CPU connector.