Installation Instructions

MAINTENANCE
116
The technical materials and information contained in this document are strictly confidential and the exclusive property of Advanced Microwave Engineering s.r.l.
These materials and information are intended solely for the purpose designated and may not be used otherwise.
It is not permitted to disclose or reproduce them in whole or in part without express written permission.
23.2 RECOMMENDED CHECK INTERVALS
Although there is a self-diagnostics for the system, before using the vehicle, always conduct a quick visual inspection of
the condition of the components, in particular the sensors and their connection cables, which are the elements highly
subject to damage caused by impacts or improper use of the vehicle.
It is also advisable to conduct a more thorough checking of the system periodically by following the procedure shown in
the table below. It can be repeated also after a major maintenance of the vehicle or after a wash, in particular if high
pressure water cleaning systems have been used.
1. Start the system and wait for the main screen to appear.
2. Check the status of the sensors; all sensor icons must be green.
3. Check the status of the sensors by pressing the relevant sensor icons. The message 'Sensor Ok' must appear for
each of the sensors.
4. Run the tag activation test as described in section 9.3.2