Owner’s Manual Please read and fully understand this manual before operating your Air Shield.
TM Advanced PureAir Air Shield Owner’s Manual SAFETY OPERATION Please exercise caution when using the Air Shield Air Purifier or any other electrical device! This manual describes the safety precautions which should be observed in relation to your air purifier. Please review carefully BEFORE using the product.
TM Advanced PureAir Air Shield Owner’s Manual CONTROLS & AIR FLOW VENTS Front Face Plate Air Outlet HI ION-UV INDICATOR MED Dust Sensor LOW with ultra-violet technology QUIET AUTO FLOW CLEAN AIR MONITOR 8HR CLEAN METAL GRID 2HR REPLACE FILTER 1HR RESET TIMER ODOR DUST ALLERGEN POWER Air Inlets Air Inlets Front Panel Release Tabs Bottom Stand Soft Touch Control Panel Odor Sensor HI Remote Control ION-UV INDICATOR MED with ultra-violet technology ON/OFF LOW 8HR CLEAN METAL GRI
TM Advanced PureAir Air Shield Owner’s Manual MAJOR COMPONENTS Back View Exploded Parts View 3
TM Advanced PureAir Air Shield Owner’s Manual BEFORE USE Pre-Installation Air Ventilation Open Windows for Air Ventilation Before plugging in the unit, please open the windows in the area where you will be using the unit. Ventilate the area for 2-3 hours if possible. Once the area has been ventilated, close the windows and plug in the unit. After plugging in, the unit sensor will sample the air and retain a memory of the existing indoor air condition.
TM Advanced PureAir Air Shield Owner’s Manual EXPLANATION OF INDICATORS Negative Ion Indicator During the process when negative ions are generated, the blue indicator on the Soft Touch Control Panel will gradually change from bright to dim and from dim back to bright every 5seconds. Odor Indicator The odor indicator on the Soft Touch Control Panel will glow whenever the odor sensor detects odor (such as indoor smoke).
TM Advanced PureAir Air Shield Owner’s Manual OPERATING INSTRUCTIONS Locate the Unit Place the Air Shield against a wall, near an electric outlet with 12-15 inches clearance on the front and sides. It is best to place the unit where it will be out of any children's play area. How to Start Plug the unit into a standard 120V/60Hz outlet. Press the POWER ON/OFF button. The device starts operating automatically and the negative-ion UV indicator will automatically turn on.
TM Advanced PureAir Air Shield Owner’s Manual CLEANING AND MAINTENANCE Before starting any cleaning or maintenance, always turn-off and unplug the unit. Regular cleaning and maintenance is recommended every 2-3 months. Disassembling the Air Shield After unplugging, carefully lay the unit down face-up. Disassemble the unit in sequence of 1 to 5 as shown below. (Put the unit back together in the reverse 5 to 1 sequence.) 3. Remove the Washable Plasma Dust Filter 1. Remove the Front Face Plate 4.
TM Advanced PureAir Air Shield Owner’s Manual CLEANING AND MAINTENANCE (CONT.) Regular Cleaning and Maintenance Unit Body Front Face Plate Can be cleaned with flowing water Please use a soft cloth to clean and avoid scraping off the paint on the cover For Instructions regarding the disassembly of the face plate and filters refer to page 7. Take down UV lamp before cleaning Avoid cleaning with hot water or rubbing too hard Use wring dry cloth to rub and clean.
TM Advanced PureAir Air Shield Owner’s Manual CLEANING AND MAINTENANCE (CONT.) Cleaning and Maintenance of the Washable Plasma Dust Filter The Washable Plasma Dust Filter needs cleaning when: 1) The cleaning indicator is glowing or blinking. 2) The dust collector is making electrical discharge sounds. 3) The device has been used frequently in an area with lower air quality condition. Cleaning Instructions 1. Remove the Front Face Plate. Washable Pre-Filter 2. Remove the Washable Pre-Filter.
TM Advanced PureAir Air Shield Owner’s Manual CLEANING AND MAINTENANCE (CONT.) The Cleaning and Maintenance of the Washable Plasma Dust Filter (Cont.) 4. Clean the Plasma Dust Filter Use mild detergent or plain water only. Use a soft scouring pad or toothbrush to clean the dust collector. Use warm water (below 40° C) only! 5. If dust and dirt does not wash away easily, pre-soak with diluted detergent and then use a toothbrush to scrub.
TM Advanced PureAir Air Shield Owner’s Manual CLEANING AND MAINTENANCE (CONT.) Replacing Filters Please change filter when the REPLACE FILTER indicator is glowing. Note: Please refer to page 7 for instructions on filter installation and removal. Replacing UV Lamp The life span of UV lamp is about 5,000 hours. Replace UV lamp when it is damaged or when no blue light is observed.
TM Advanced PureAir Air Shield Owner’s Manual FREQUENTLY ASKED QUESTIONS Air Quality Surveillance Why is there is only one LED glowing all the time with the air quality surveillance function? Indoor air has been clean the whole time. For testing purpose, dust either caused by a cigarette or a dusty cloth can be released near the irritant sensor. If the level of pollution goes up, then the unit should be operating properly. The irritant sensor could be too far away from any irritant for it to detect.
TM Advanced PureAir Air Shield Owner’s Manual FREQUENTLY ASKED QUESTIONS (CONT.) Filter Why is it so hard for the filter to get rid of dust and odors? Have the front and back of the HEPA/Charcoal filter been mistakenly reversed? The HEPA/Charcoal filter has been saturated with a serious amount of dust. (Usually dark grey in color). Please replace filter. Plasma Dust Collector Why is it so difficult to eliminate dust and odor? If the electrical discharge wires or the plasma dust collector gets too dirty.
TM Advanced PureAir Air Shield Owner’s Manual TECHNICAL SPECIFICATIONS Real Spirit Style No.: Air Shield Dust Removal Rate: 1 micron 99.97% • 0.3 micron 80% Rated Voltage: AC 120V/60Hz Noise Level (dB): Quiet 20 • Low 35 • Med 45 • High 52 Power Consumption: 80W Air Volume (High): 3 m3/min. • 106 ft3/min. Ion Output: ˃ 2 x 106/cm3 Dimensions: 13.5" x 10" x 25.6” • 343 x 255 x 610 mm Activated Oxygen Output: ˂ 0.05 ppm Weight: 15.1 lbs • 6850 g 2 UV Spectrum: ˃ 20μ w/cm at 10 cm distance.
Produced and distributed exclusively by: Real Spirit USA, Inc. • 9447 De Soto Ave • Chatsworth, CA 91311 Customer Service Phone 888.698.2080, ext. 210 www.AdvancedPureAir.com • info@RealSpiritUSA.com © Copyright Real Spirit USA, Inc. 2008.