User's Manual

Page 46
E-STOP
START POWER ON/OFF
Y 0
X 0
0 Y
0 X
PressSTART
7. Operating Procedure
7.1 General Operating Procedure
a. Reset the red emergency stop button located on the left hand side of the transmitter
by pulling it upward or rotating it clockwise.
b. Turn on the transmitter power by inserting the black-colored key into the keyswitch
slot located on the right hand side of the transmitter and rotate it clockwise to “On”
position.
c. After turning on the transmitter power the LCD screen will display “ PressSTART”.
Press the green START button next to the power keyswitch for up to one
(1) second to activate (connect) the receiver mains.
→ Press Start →
d. Available icons:
Main Screen Start Normal Toggle A B A+B Infrared
e. In case of an emergency, pressing the red e-stop button will immediately
disconnect the receiver mains (LCD turns off). Pull it upward or rotate the red
button clockwise to reset the e-stop button. Press the green START button for up
to one (1) second to reconnect the receiver mains when “ PressSTART”
reappears on the LCD screen.
f. After 5 minutes of inactivity the receiver mains are disconnected temporarily
(depends on transmitter inactivity timer set on section 4.1.4). Press the green
START button to reconnect the receiver mains and continue operation.
g. Turn off the transmitter power by rotating the power key counter-clockwise to “Off”
position; it will disconnect the transmitter power and the receiver mains altogether.
Turn it further counter-clockwise to release the key.