User's Manual

Page 48
7.3 Automatic Channel Scanning Operating Procedure
When transmitter channel is changed (see section 4.1.2) press the green START button
for up to 60 seconds to re-connect with the receiver unit. Make sure the receiver unit is
set to Scan “ALL” in the receiver channel scanning section 4.2.4.
7.4 Battery Charging Instruction
When battery pack is inserted it will automatically go into charging mode. Press the
Charge/Discharge button to switch from charging to discharging, or vise versa.
Power On → Charge LED blinks green 3 times.
Charging → Charge LED blinks green constantly.
Discharging → Discharge LED blinks red constantly.
Fully charged → Charge LED constant green.