User's Manual

Flex ECO 4S/4X/8S/8X/12S/12X Instruction Manual
April 2015
Page 14 of 36
4.1.3 Remote Pairing
A. Transmitter-to-Transmitter Pairing:
1) After entering the Function Setting Mode (refer to
section 4.1.1 Enter Function Setting Mode).
2) Press and hold both PB3 and PB4 for up to 1
second (Status LED blinks orange).
3) Release PB3 and PB4 (Status LED turns off).
4) Entered Remote Pairing Mode.
5) Output data (original transmitter) by press and hold
PB3 (Status LED blinks green).
6) Receive data (new transmitter) by press and hold
PB4 (Status LED blinks green).
7) When the Status LED (receiving data end) turns to constant green while both
pushbuttons are still pressed down the pairing is completed.
8) Exit Function Setting Mode by pressing down the STOP button and set the dip
position #10 back to “0” or OFF position.
9) Reset the STOP button and then press the START button to resume operation.
→
Output data – original transmitter Receive data – new transmitter
(press and hold PB3) (press and hold PB4)
B. Receiver-to-Transmitter Pairing:
JP8 Open Method: After entering the Remote Pairing Mode, output receiver data by press
and hold the Pairing button located on the receiver cover and receive data by press and hold
PB4 on the transmitter, both at the same time. When the transmitter Status LED turns to
constant green while both pushbuttons are still pressed down the pairing is completed.
→ →
Set JP8 to “Open” Output data - receiver Receiving data – transmitter
(Press and hold the Pairing button) (Press and hold PB4)
JP8 Short Method (wireless pairing): After entering the Remote Pairing Mode, press PB1 on
the transmitter one time and then press and hold PB3 for up to 6 seconds. The Status LED blinks
green when PB3 is pressed. Release PB3 when Status LED turns off the pairing is completed.
Make sure the pairing process is executed within a distance of 10 meters from one another.