User's Manual

Page 35

3rd

SPEED

e. In case of an emergency, press down the red emergency stop button will immediately disconnect

the receiver MAIN and as well as the transmitter power. To resume operation, rotate the red button

clockwise or counter-clockwise, it will pop up. Then rotate the power key-switch to START

position for up to 1.0 second to activate all transmitter push button functions and the receiver

MAIN. Please note that every time when you turn the transmitter power off and back on again or

after resetting the emergency stop button, all push button functions will be locked to avoid any

unintentional controls. For safety, initiating the START command after turning on the transmitter

power or after resetting the emergency stop button is strictly required. The receiver MAIN will

also be disconnected temporarily when the receiver encounters strong radio interference or when

the operator is controlling the crane or equipment beyond the transmitting range.

f. Turn off the transmitter power by rotating the power key counter-clockwise to “Off” position; it

will disconnect the transmitter power and the receiver MAIN altogether. Turn it further

counter-clockwise to release the key.

WARNING

Keep away interference source to make sure performance integrate..

2. A/B Selector Push Button Operating Procedure

Pressing the “Select A/B” push button will toggle between output relay A, B, A+B respectively. There

are 4 different types of Select A/B sequence available, please refer to page 11~13 for instructions on

how to set Select A/B functions.

3. 3

Speed Push Button Operating Procedure

When a push button is hold at 2

speed, pressing the 3

Speed push button one time will activate the 3

speed output relay (toggled). If the operator wants 2

speed again, just press the 3

Speed push button

one more time.