User's Manual

Page 36
O
N
O
F
F
C
A
T
C
H
C
A
T
C
H
C
A
T
CH
PITCH
P
I
T
C
H
1
2
4. Pitch & Catch Operating Procedure
To release control of the crane, press the “Pitch” push button. To take over control of the crane, rotate the
power key switch to “Catch” position for up to 2 seconds. The 2
nd
operator “can not” take control of the
crane unless the 1
st
operator presses the “Pitch” push button (2.0 seconds). If the operator unintentionally
presses the “Pitch” push button during operation, just rotate the power key to “Catch” position for up to
2 seconds to regain control again.
→ →
5. Automatic Channel Scanning Operating Procedure
After changing transmitter channel (refer to page 9), turn on the transmitter power and rotate the power
key switch to “Start” position and hold it there for up to 1.0 minute. Within this 1-minute period the
receiver will search (channel 01 ~ channel 62) and lock onto the newly selected transmitter channel
automatically. Please note that in order for the receiver to switch to auto-scanning mode, prior to
changing the transmitter channel, you must first deactivate the receiver MAIN by shutting off the
transmitter power or press down the emergency stop button. Please refer to page 25 if you do not want
the receiver to auto-scan all 62 channels.
Change Transmitter Channel →
6. Changing Transmitter Batteries
Changing transmitter batteries by unscrewing the battery cover located on the backside of the transmitter
(refer to Fig. 20 below). During battery installations make sure that the blue ribbon is centered between
the two batteries. After changing the batteries also make sure that all screws are tightened to avoid water,
moisture, dirt, grease, or other liquid penetration.
(Fig. 20)
↓