User's Manual

Flex 8ES/EX Standard, AB and Tandem Instruction Manual
September 2016
Page 37 of 42
Master Transmitter Takeover Procedure
Press PITCH Rotate to B position Rotate to START
 
(After 2 seconds)
Slave transmitter Master transmitter Master transmitter
Slave Transmitter Takeover Procedure
Rotate to B position Press PITCH Rotate to START
 
(After 2 seconds)
Master transmitter Master transmitter Slave transmitter
b. Once the transmitter is locked on to both receivers, rotate the selector switch to either
A, B, or A+B position for independent or simultaneous operation.
c. At beginning of each shift prior to turning on the transmitter power, always check if the
selector switch is correctly positioned for the intended receiver or receivers.
d. For safety, there is a 2-second grace period followed after executing the PITCH
command. What this means is that when PITCH pushbutton is pressed, executing the
START command on the other transmitter within this 2-second grace period is
ineffective. In order to gain control of the other receiver you must first wait for up to 2
seconds after the other transmitter presses the PITCH pushbutton and then for you to
execute the START command thereafter.