User's Manual

Page 23
PS1 PS2
>I-CHIP
COPY I/O
PROCEED
>S/N:
0000001 ABCDEFGH
>TYPE:
01
>CHANNEL
433.000
>FREQ:
ALL
>CH SCAN
>MAIN RLY
NORMALLV
>FUNCTION1>FUNCTION2
LV
>LX DELAY
ACC OFF
DEC OFF
ACC OFF
>LY DELAY
DEC OFF
ACC OFF
>RX DELAY
DEC OFF
ACC OFF
>RY DELAY
DEC OFF
>SW1&2 RLY
UNLOCK NORMAL
>SW1 RLY >SW2 RLY
NORMAL NORMAL
>SW3 RLY
UNLOCK
>SW4&5 RLY
NORMAL
>SW4 RLY
NORMAL
>SW5 RLY>SW6&7 RLY
UNLOCK
>SW6 RLY
NORMAL
>SW7 RLY
NORMALYES NO
>SAVE?
SETTING
MODE
>I-CHIP
COPY I/O
PROCEED
4.2 Receiver Unit
4.2.1 Programming Procedures
How to enter receiver programming mode:
1) Switch on the receiver power.
2) Press both PS1 and PS2 buttons below the LCD screen at
the same time for up to 1 second to enter the Programming
Mode. Setting Mode screen will show up for a brief second
followed by the I-Chip Copy I/O (see below).
3) Serial number and frequency range can not be reprogrammed directly on the
transmitter so press PS2 button repeatedly until you see the Channel Setting
screen and so on.
4) Button functions:
PS1 button is the “Enter” or “Change” command.
PS2 button is the “Next” command.
Press and hold PS2 and then PS1 to go back to the previous main menu.