User's Manual

Page 52
9. Trouble Shooting Tips
Problems Possible Reasons Suggestions
Transmitter low battery Check the transmitter battery level.
Emergency stop button
activated prior to startup
Prior to turning on the transmitter power
make sure that the red emergency stop
button is elevated.
Improper startup procedure Redo the startup procedure.
Incorrect system channel
Check and make sure the transmitter
and receiver are with same channel.
Incorrect system serial
number
Check and make sure the transmitter
and receiver are with same serial
number.
No response when
transmitter is in
operation
(Improper startup &
settings)
System out of range
Make sure the startup procedure is
initiated within 100 meters from the
receiver location.
Defective transmitting and
receiving module
Check the SQ display on the face of the
receiver unit. If it does not light up when
operating the transmitter then either the
transmitting or receiving module is
defective. Replace the transmitting
module first then the receiving module.
No response when
transmitter is in
operation
(Damaged hardware)
Defective encoder
board or decoder module
If still no response after replacing the,
transmitting and receiving modules then
replace the transmitter encoder board. If
still doesn’t work then the decoder
module is defective.
Incorrect input voltage
Make sure the source voltage is set
correctly.
Blown fuse Check for any blown fuse.
No AC power to the
receiver
Incorrect wiring Check input voltage connection.
Outputs do not
correspond to
transmitter
Incorrect output connection Check the system wiring again.