User's Manual

Epoch-S02 RF Repeater
User Manual V1.1
1.5 Step by Step Instructions for Installation
1.5.1
r
Repeater Setup
1. Mount the Repeater Bracket (Option)
Position the I-shape repeater bracket (ISRB01) at the desired location.
Using the 8 screws (SC01) provided, fasten the bracket securely.
2. Attach Repeater to the Mounting Bracket (Option)
Using the 4 bolts (BLTS01) provided, fasten the repeater (Epoch-S02) to
the bracket.
3. Open the Epoch-S02
Open the front door of the repeater cabinet by using the key (KEYS01)
provided. There are two locks integrated into the door latches. One key
works for both locks.
** Please keep the cabinet door open fully during the installation until
you are instructed to close the cabinet. When opening the door, wait
until the latch clicks to prevent inadvertent closure of the doo .
4. Connect the Power Source and Ground Wire
Make sure that the power switch inside the repeater is off before
connecting the power cable. Connect the power cable to the power
source. Connect the ground wire (GNDSTD01) to the ground connector.
** Before connecting the power cable to the power source, make sure that
the voltage source is 110 V.
5. Connect the Donor Antenna
Connect one end of the cable to the Donor Antenna and the other end to
the repeater Donor on the bottom of the Epoch-S02.
6. Connect the Server Antenna
Connect one end of the cable to the Server Antenna and connect the
other end to the repeater Server on the bottom of the Epoch-S02.
7. Initialize the Epoch-S02
Using RS232 straight through serial cable, connect one end of the cable
to the Epoch-S02’s NMS port located on the bottom of the repeater and
the other end to the laptop’s serial port.
Advanced RF Technologies, Inc. Proprietary Document Page 10 of 31