User's Manual

Epoch-S02 RF Repeater
User Manual V1.1
By default, the Uplink Tracking ON box is enabled and the Uplink Tracking Offset
is set to 0 dB, meaning the uplink gain will always equal the downlink gain.
Control Item Action Setting Value
Uplink Tracking Mode Set Uplink Tracking Mode ON/OFF
Tracking Gain Offset Set Tracking Gain Offset 0 ~ +25 dB @ 0.5 dB Steps
Table 2.1.3.1 Uplink Tracking Mode and Tracking Gain Offset Range
Downlink/Uplink Gain
The gain of the Epoch-S02 is the ratio of the input signal to the output signal.
The gain may be set in both links.
NOTE: The manual gain option is disabled when the AGC Mode is set ON.
System Reboot
Clicking the “System Reboot” button will execute any awaiting actions
immediately that were taken using the OMS program. The changes are reflected
in the status window. Also, clicking on the button will load the repeater with
last saved configurations.
System Factory Setting
The “Factory Setting”
button resets the settings of the repeater to the original
default factory settings as noted in the “Default Control Settings” in Section 2.4.
Advanced RF Technologies, Inc. Proprietary Document Page 17 of 31