User's Manual
Table Of Contents
- Installation Guide for Epoch-S02
- Environmental requirements
 - Warnings and Hazards
 - Tools and Recommendations for Installation
 - Epoch-S02 Parts List
 - Step by Step Instructions for Installation
 - User Manual V1.1 using OMS V4.01
 - Menu Structure
 - Using the Epoch-S02 OMS V4.01
 - Alarms
 - Default Control Settings
 - Maintenance Guide for Epoch-S02 OMS V4.01
 - Periodic Inspection Checklist
 - Preventive Measures for Optimal Operation
 - Troubleshooting
 - Epoch-S02 OMS V4.01 Scenarios
 - Heartbeat Scenarios
 - Warranty and Repair Policy
 - General Warranty
 - Specific Product Warranty Instructions
 - A.1 Minimum Requirements
 - A.2 Epoch-S02 OMS V4.01 Installation/Startup
 
 - Appendix B: Specifications
 
    Epoch-S02 RF Repeater 
User Manual V1.1 
Heartbeat 
  Heartbeat is a periodic message sent out to Sprint PCS’ NOC. 
Heartbeat On/Off  Set Heartbeat Mode  ON/OFF 
Heartbeat Time  Set Heartbeat Time  1 ~ 60 min @ 1 min Steps 
Table 2.1.3.3 Heartbeat Mode and Time Ran
g
e 
 Heartbeat Mode 
The Heartbeat ON box is enabled by default. 
Periodic Time 
The Periodic Time is the time interval between Heartbeats. The default time is 
20 minutes. 
2.1.4  Install Menu 
At the time of installation, the installer/technician needs to open the Install Menu 
of the Epoch-S02 OMS V4.01. The Install Menu will guide the 
installer/technician through a step by step process to properly install the Epoch-
S02 Repeater. 
For setup or installation of a repeater, click “Install”
on the menu bar of the Main 
Window. 
Figure 2.1.4 Install Window of the Epoch-S02 OMS V4.01 
Advanced RF Technologies, Inc. Proprietary Document  Page 19 of 31 










