User's Manual

Epoch-S02 RF Repeater
User Manual V1.1
Band
Select the desired band or bands by clicking the appropriate buttons.
You can deselect the undesired band or bands by clicking the button
again. You can select among total 15 band combinations; A, B, C, D, E, F,
AD, AE, AF, BD, BE, BF, CD, CE and EF. Neither two 5 MHz bands nor two
15 MHz bands can be selected at any given time.
SNMP
1. Site ID
The “Site ID” is a unique ID for each site and will be provided by Sprint
PCS.
2. Manager IP
The “Manager IP” address will be provided by Sprint PCS. The repeater
will send alarms to the Sprint PCS’ NOC via the Manager IP address.
Modem
The “Auto Connection” box needs to be checked when the modem is
installed inside the repeater. A 3G wireless modem is used in order to
send the alarms and the heartbeat over the air to Sprint PCS’s NOC.
Repeater
Click the “Install” button and the repeater will setup automatically.
2.1.4.1 Pre-Installation
Prior to the Epoch-S02 Installation, ensure that:
1. The correct Com port is selected.
2. The donor and server antennas are in place.
3. The TX and RX communication status lights are operating.
The TX status light should blink every 3 seconds. A blinking RX
(red) status light indicates that the laptop/PC is retrieving data
from the repeater (Epoch-S02). Similarly, a blinking TX (green)
light indicates that the laptop/PC is transmitting data to the
Epoch-S02.
If neither of the lights is blinking, check the Com port setting of
your laptop/pc by choosing the port to which the serial port is
assigned.
Advanced RF Technologies, Inc. Proprietary Document Page 20 of 31