User's Manual

Epoch-S02 RF Repeater
User Manual V1.1
2.3.2 Downlink/Uplink Alarms
Alarm List Soft Fail Hard Fail Remark
RSSI O -
Input Power Overload O -
Over Power* O O
Downlink
(Forward)
RF Power O -
RSSI O -
Input Power Overload O -
Uplink
(Reverse)
Over Power* O O
Alarms will turn on if the
value is not within operable
limit specified in the
parameters set in the
Control Alarm Setting Menu.
Table 2.3.2 Adjustable Alarm Settings of the OMS V4.01
* The example below distinguishes the difference between an Over Power Soft Failure
and an Over Power Hard Failure.
If the threshold value for the Downlink Over Power parameter was set to 23.0
dBm, a Hard Fail alarm would occur if the Downlink Over Power value was greater
than 24.0 dBm (23.0 +1). Similarly, a Soft Fail alarm would occur if the Downlink
Over Power value was greater than 23.0 dBm but less than 24.0 dBm. The same
example also applies to the Uplink direction.
2.4 Default Control Settings
2.4.1 Default General Setting
Control Item Setting Value
AGC Mode ON
Downlink/Uplink
HPA Mode ON
Uplink Tracking Mode ON
Downlink/Uplink Gain 80 dB
Tracking Gain Offset 0 dB
Table 2.3.3 Adjustable Alarm Settings of the OMS V4.01
1. When Uplink Tracking Mode is set ON, by default, the Tracking Gain
Offset is 0 dB.
Advanced RF Technologies, Inc. Proprietary Document Page 24 of 31