User's Manual

Epoch-S02 RF Repeater
User Manual V1.1
1.3 Tools and Recommendations for Installation
The following may be necessary (not required) for installation of the repeater:
1. Crescent Wrench or drill with drill bit attachment of …
2. Philips Screw Driver
3. Lift, Ladder, or boom truck
4. Spectrum Analyzer
5. Sweep Tester
6. Signal Generator
7. Pilot Scanner
8. RF Power Meter
9. Voltmeter
10. Coaxial cables
11. Compass
12. Laptop or PC with an RS-232 serial port (with Epoch-S02 OMS V4.01
Software installed)
The list above may vary depending on if brackets are used to install the repeater.
Bring additional tools that may be useful in installation. It is recommended that
two people install the Epoch-S02 Repeater system.
Please maintain a safe distance of 27 cm while operating near the donor and the
server antennas (Assuming the maximum gain of either of the antennas do not
exceed 15 dBi).
MPE WARNING!
Operating the Epoch-S02 with antennas in very close
proximity facing each other could lead to severe
damage to the repeater.
WARNING!
Advanced RF Technologies, Inc. Proprietary Document Page 8 of 31