User's Manual

Epoch-S02-19001W RF Repeater
User Manual V1.0
Advanced RF Technologies, Inc. Proprietary Document Page 11 of 32
3. Open the Epoch-S02-19001W
Open the front door of the repeater cabinet by using the key (KEYS01)
provided. There are two locks integrated into the door latches. One key
works for both locks.
** Please keep the cabinet door open fully during the installation until
you are instructed to close the cabinet.
4. Connect the Power Source and Ground Wire
Make sure that the power switch inside the repeater is turned off before
connecting the power cable. Connect the power cable to the power
source as shown in Figure 3 (# 3). Connect the ground wire (GNDSTD01)
to the ground connector as shown in Figure 3 (# 5).
** Before connecting the power cable to the power source, make sure that
the voltage source is 110 V.
5. Connect the Donor Antenna
Connect one end of the RF coaxial cable to the donor antenna and the
other end to the repeater donor port located on the bottom of the Epoch-
S02-19001W as shown in Figure 3 (# 2).
6. Connect the Server Antenna
Connect one end of the RF coaxial cable to the server antenna and
connect the other end to the repeater server port located on the bottom
of the Epoch-S02-19001W as shown in Figure 3 (# 4).
Figure 3 – Bottom Side of the Repeater
# 1 - NMS Port
# 2 - Donor
Antenna Port
# 4 - Server
Antenna Port
# 5 - Ground Port
# 3 - AC Power Supply