User's Manual
Table Of Contents
- Introduction of Epoch-M1P
- Overview
 - Warnings and Hazards
 - Epoch-M1P Parts List
 - Epoch-M1P Software Installation and Requirements
 - 1.4.1 Minimum PCS Requirements
 - 1.4.2 Epoch-M1P Software Installation
 - ** Refer to the Software Setup Guide
 - ** Refer to the USB Setup Guide
 - Pre-Installation using Epoch-M1P Software
 - Step by Step Instructions for Installation
 - User Manual V1.0 using Epoch-M1P Software
 - Menu Structure
 - Using the Epoch-M1P Software
 - Alarms
 - Default Control Settings
 - Maintenance Guide for Epoch-M1P
 - Periodic Inspection Checklist
 - Preventive Measures for Optimal Operation
 - Troubleshooting
 - Tx & Rx LEDs
 - Common Installation Problems
 - Warranty and Repair Policy
 - General Warranty
 - Limitations of Warranty
 
 
    Epoch-M1P RF Repeater 
User Manual V1.0 
2.1.3.2  Alarm Setting Window 
Figure 8 - Alarm Setting Window of the Epoch-M1P Software 
Heartbeat 
Heartbeat is a periodic message sent out to Wireless Provider’s NOC 
only if the 
repeater comes with a wireless modem
. 
Control Item  Action  Setting Value 
Heartbeat ON/OFF  Set Heartbeat Mode  ON/OFF 
Periodic Time  Set Heartbeat Time  1 ~ 60 min @ 1 min step 
Table 4 - Heartbeat Mode and Time Ran
g
e 
 Heartbeat Mode 
The Heartbeat ON box is checked by default. 
The heartbeat feature is only 
available if the repeater has a wireless modem. 
Periodic Time 
The 
Periodi  Time
 is the time interval between Heartbeats 
only if the repeater 
has a wireless modem connected to it
. The default periodic time is 20 minutes.  
The periodic time can be adjusted manually between 1 to 60 minutes. 
c
Date & Time 
If the repeater doesn’t come have a wireless modem, you need to set the date 
and time manually in order for the Log File to reflect accurate information in 
terms of when the data was generated. 
Advanced RF Technologies, Inc. Proprietary Document  Page 19 of 38 










