User's Manual
Table Of Contents
- Introduction of Epoch-M1P
- Overview
- Warnings and Hazards
- Epoch-M1P Parts List
- Epoch-M1P Software Installation and Requirements
- 1.4.1 Minimum PCS Requirements
- 1.4.2 Epoch-M1P Software Installation
- ** Refer to the Software Setup Guide
- ** Refer to the USB Setup Guide
- Pre-Installation using Epoch-M1P Software
- Step by Step Instructions for Installation
- User Manual V1.0 using Epoch-M1P Software
- Menu Structure
- Using the Epoch-M1P Software
- Alarms
- Default Control Settings
- Maintenance Guide for Epoch-M1P
- Periodic Inspection Checklist
- Preventive Measures for Optimal Operation
- Troubleshooting
- Tx & Rx LEDs
- Common Installation Problems
- Warranty and Repair Policy
- General Warranty
- Limitations of Warranty
Epoch-M1P RF Repeater
User Manual V1.0
2.1.5.2 Upgrade Window
In order to download the latest repeater firmware, click on the Upgrade
Window. The firmware file will be provided by the technical support group
from Advanced RF Technologies, Inc. Once the firmware file has been saved
on the PC, you would connect the Epoch-M1P repeater to the PC via the USB
cable provided. Click on “Open” and locate the firmware file and click on
‘Download.”
Figure11 - Upgrade Window of the Epoch-M1P Software
Once the firmware has been downloaded successfully, the following pop-up
window will appear.
Advanced RF Technologies, Inc. Proprietary Document Page 24 of 38