User Manual

Epoch-M1C RF Repeater
User Manual V1.1
Advanced RF Technologies, Inc. Proprietary Document Page 30 of 38
4 Troubleshooting
4.1 Tx & Rx LEDs
Tx Rx Explanation
Blinking
GREEN
Blinking
GREEN
Successful Connection. The Epoch-M1C Software and the
repeater are communicating successfully.
Blinking
GREEN
Solid
GREEN
The repeater is not receiving any commands from the
software. In this state, the repeater is either processing or
executing a command. Wait for a few seconds for the Rx LED
to blink periodically.
Blinking
GREEN
RED
The repeater is not receiving any commands from the
software. Ensure that the repeater is tuned on and check for
proper USB port connection.
RED RED
The USB port can not send or receive data. Check if the USB
driver has been installed and also verify if the physical
connection on both ends of the USB cable is secure. Ensure
that the repeater is turned on.
** The Tx/Rx LEDs will blink periodically only on the Status Window.
Table 11 - Tx and Rx LEDs