User Manual

Epoch-HP RF Repeater
User Manual V1.1
Advanced RF Technologies, Inc. Proprietary Document Page 11 of 36
2.4 Tools and Recommendations for Installation
The following may be necessary (not required) for installation of the repeater:
a. Crescent Wrench
b. Philips Screw Driver
c. Lift, Ladder, or Boom Truck
d. Spectrum Analyzer
e. Sweep Tester
f. Signal Generator
g. Pilot Scanner
h. RF Power Meter
i. Voltmeter
j. Coaxial Cables
k. Compass
l. PC with an USB port
The list above may vary depending on if brackets are used to install the repeater.
Bring additional tools that may be useful during installation. It is recommended
that two people install the Epoch-HP repeater system.
2.5 Epoch-HP Parts List
The Epoch-HP repeater system includes:
PART ID
QUANTITY
a. Epoch-HP Repeater EPOCHHP01 1
b. Nuts and Bolts BLTS01 4
c. Epoch-H V1.X GUI HPOMS01 1
d. Ground Cable GNDSTD01 1
e. USB Cable USB01 1
f. Keys KEYS01 2
2.6 Epoch-H V1.X Installation and Requirements
2.5.1 Minimum Requirements
Hardware (PC Platform)
CPU: 200 MHz
Memory: 32 MB
Hard Disk: 10 MB (Free Space)
USB Port: 1 Port
CD-ROM Drive
Compatible Operating System:
Microsoft Windows XP (Preferred), 2000