User Manual

Epoch-S02-19002W RF Repeater
User Manual V1.3
Advanced RF Technologies, Inc. Proprietary Document Page 13 of 33
8. Turn On the Power for Epoch-S02-19002W
Make sure that the donor and server antennas and the power cable are
securely connected to the correct ports. Turn the power switch on,
located inside the repeater.
9. Launch the Epoch-S02 OMS V4.XX Program
Open the Epoch-S02 OMS V4.XX program. You will see the Status
Window.
** For more detailed information on the Epoch-S02 OMS V4.XX, please
refer to Section 2 on page 15.
10. Select Proper COM Port
From the Status Window of the Epoch-S02 OMS V4.XX, select the correct
COM port setting at the lower right hand side of the window (refer to
Section 2.1.1 on page 15).
** Please make sure that both communication status LEDs, the TX and the
RX on the bottom of the window, are blinking periodically. A green
blinking TX LED indicates that the data is being transmitted from the PC
to the Epoch-S02-19002W. A green blinking RX LED indicates that the
data is being retrieved from the Epoch-S02-1900 to the PC.
** If either the TX or the RX status LED is not blinking, check the COM
port setting of your PC and choose the port to which serial port is
assigned. For more information, refer to Section 4, “Troubleshooting” on
page 27.
** Before proceeding to the next step, please close the cabinet door (do
not lock) at this time in order to avoid inadvertent RF feedback going
inside the repeater.”