User Manual

Epoch-S02-19002W RF Repeater
User Manual V1.3
Advanced RF Technologies, Inc. Proprietary Document Page 15 of 33
13. Provide SNMP Information
Type in the Site ID and the Manager IP address as given to you by the
Wireless Provider. Once both the parameters are typed in, you must click
“Set” for it to be executed.
14. Check the Modem Connection
Verify that the
Auto Connection box is checked and then click on
“Connect.”
15. Click on Install
After the first three steps, click on “Install.” This installation process will
normally take less than 5 minutes.
** Please refer to the “Quick Installation Guide” for any questions or
problems that you may encounter during this installation process.
If a modem is not connected to the repeater and you click the “Install”
button, the following pop-up window will appear:
If you choose to continue with the RF portion only, simply click “Yes” and
the installation process will resume again.
16. Check the Front LED Panel
Check that the Power LED is on (Green) and neither Soft Fail LED (Yellow)
nor Hard Fail LED (Red) is lit.
** If the Soft Fail or Hard Fail LED is on, refer to Section 2.3 on page 23.
** You can go to the Status Window of the OMS V4.XX program to view
the basic parameters of the repeater once the repeater has installed
successfully.