User Manual

Epoch-S02-19002W RF Repeater
User Manual V1.3
Advanced RF Technologies, Inc. Proprietary Document Page 17 of 33
2.1.2 Status Window
The Status Window is the monitoring window of the Epoch-S02 OMS
V4.XX. This window enables the user to monitor the status and settings
of the Epoch-S02-19002W. In other words, no parameters can be
changed in the Status Window. To change parameters, you will need to
go to the Control Window.
Band Selection
Currently selected band(s)
are highlighted.
Repeater Input
Indicates input
signal strength of
the repeater after
being amplified by
the donor antenna
[in dBm].
Repeater Output
The output of the
repeater [in dBm]
before being radiated
by the server antenna.
Repeater Gain
Indicates the gain
of the repeater
[in dB].
Alarm Button
The alarm button changes color
to the corresponding status of
the repeater:
Green for normal
operation;
Yellow for soft fail
alarm; and
Red for hard fail
alarm. Click on the alarm
button for detailed information.
Message Board
The user will be able to see heartbeat messages
which are sent out recently. In addition, the user
will also be able to see any alarms that are
generated along with messages once the alarms are
cleared as well.
Status Bar
Displays the status of the repeater (e.g. Status
Window Loaded Properly, etc.), transmit (TX)
and receive (RX) communication LEDs, and
COM ports (e.g. COM1, etc.).
Figure 6 - Status Window of the Epoch-S02 OMS V4.XX
Installation
Will let you know if the
repeater is properly
installed.
Modem Connection
If the modem has properly
established a PPP session.
Log File
History for the
heartbeats and alarms
generated from the
repeater and can be
saved as a text file.
Clear
Will clear the
Message Board.