User Manual

Epoch-S02-19002W RF Repeater
User Manual V1.3
Advanced RF Technologies, Inc. Proprietary Document Page 18 of 33
2.1.3 Control Menu
2.1.3.1 General Setting Window
AGC Mode
AGC (Auto Gain Control) adjusts the variable gain of the repeater to ensure a
constant specified output power of 33 dBm. The functionality of the AGC feature
is assured under the condition that the input BTS signal is within the specified
AGC range (-66 to -26 dBm) and that sufficient isolation exists between
antennas (≥ 103 dB). By default, the
AGC ON box is checked. To manually
change the gains in both the links,
AGC ON must be unchecked.
If AGC ON is checked and Uplink Tracking ON is unchecked, the user can specify
the AGC level in the downlink and in the uplink respectively @ 0.5 dB step (0 to
24 dBm). By default, the AGC Level is set to 33 dBm in each link.
By default,
AGC ON and Uplink Tracking ON are both checked, this allows the
user to set the AGC level in the downlink only. If
Uplink Tracking ON is
unchecked, then the user can set the AGC level in both links.
Downlink/Uplink HPA Mode
The HPA mode enables the user to turn the HPA on or off. If the HPA is turned
off on either link, the Epoch-S02-19002W will not operate properly. Both HPAs
needs to be turned on for the RF portion of the repeater to work in both
directions (downlink and uplink). By default, the
Downlink/Uplink HPA ON box is
checked.
Figure
7
-
G
eneral
Settin
gWindow
of
the
Epoch
-
S02
OMS V4.XX