User Manual

Epoch-S02-19002W RF Repeater
User Manual V1.3
Advanced RF Technologies, Inc. Proprietary Document Page 24 of 33
2.3 Alarms
All the various alarms that are supported by Epoch-S02-19002W can be viewed by
clicking the “Alarm” button on the Status Window. If a soft fail alarm should occur,
the alarm of concern would be highlighted in yellow. In the same manner, the
corresponding hard fail alarm would be highlighted in red. In order to find out what
is causing the alarm(s), simply place the mouse cursor over the highlighted yellow or
red alarm box
(Note: only applicable to some of the alarms) and a tool tip message
will appear, displaying the threshold value and the current measured value. To
update the window, click the “Refresh” button.
Control Menu
General
Setting
Alarm
Setting
Reboot
Factory Setting
Manual Gain Control*
AGC Level Control*
Uplink Tracking Offset
Periodic Time
RSSI*
Input Overload*
Figure 11 - Variable Parameters in the Epoch-S02 OMS V4.XX
Figure 12 - All Alarm Parameters Supported by Epoch-S02-19002W