User Manual

Epoch-S02-8002W RF Repeater
User Manual V1.0
Advanced RF Technologies, Inc. Proprietary Document Page 10 of 33
1.4 Epoch-S02 OMS V1.XX Installation and Requirements
1.5.1 Minimum Requirements
Hardware (PC Platform)
CPU: 200 MHz
Memory: 32 MB
Hard Disk: 10 MB (Free Space)
Serial Port: 1 Port (RS-232)
CD-ROM Drive
Compatible Operating System:
Microsoft Windows2000, XP (Preferred)
1.5.2 Epoch-S02 OMS V1.XX Installation
Installing the Epoch-S02 OMS V1.XX
a. Insert the CD into the CD-ROM drive.
b. Click on “My Computer.”
c. In the “My Computer” window, click on your CD-ROM drive (usually
labeled D:).
d. Double-click the file labeled “setup.exe.”
e. The installation wizard will guide you through the conclusion of the
Epoch-S02 OMS V1.XX installation process.
1.5.3 Initial Startup of Epoch-S02 OMS V1.XX
a. Using the straight-through serial cable (SCST01) that is provided,
connect one end of the cable to the PC RS-232 serial port and the
other end to the repeater’s DB9 port (labeled as NMS) located on the
bottom of the repeater.
b. Open the Epoch-S02 OMS V1.XX software
c. In the Status Window, choose the right communication port: COM1,
COM2, COM3, or COM4 (the default setting is COM1). Refer to
section 2.1.1 for additional information on page 15.
** If your PC does not have a serial port and only supports USB
connection, you will then need a USB-to-Serial adapter so that it can
connect to the straight-through serial cable that is provided.
d. Click on
the Status Window again to refresh the window.