User's Manual

SDR Repeater
User Manual V0.4
Page | 15
3.5 Installation
3.5.1 Wall Mount Procedure
 Verify that the SDR and mounting hole are in
good condition
 Remove all SDR modules from the system
 Place the SDR chassis up against the wall so
that that module’s RF ports face the ceiling
 Mount the SDR chassis to wall use the six (6)
mounting hold on the wall mount bracket
 Install the SDR modules into the chassis and
secure the module by tightening the four (4)
hand screws
 Connect the power and data cables at the
bottom on the SDR
 Connect the GND cable
 Connect the Antenna cable
 Connect the Power cable
3.5.2 Rack Mount Procedure
 Verify that the SDR and mounting hole are in good condition
 Remove all SDR modules from the system
 Install the SDR chassis into the 19” rack mount system
 Screw the SDR chassis into the 19” rack mount system using the eight (8) mounting holes
 Install the SDR modules into the chassis and secure the module by tightening the four (4) hand screws
 Connect the power and data cables at the back of the SDR
 Connect the GND cable
 Connect the Antenna cable
 Connect the Power cable
Wall Mount
Bracket
Figure 8: SDR
Wall Mount
Figure 7: SDR
Rack Mount