User's Manual

SDR Repeater
User Manual V0.4
Page | 19
4. SDR Web-GUI Setup
The Web-GUI allows the user to communicate with the repeater either locally or remotely. To connect to the repeater
locally, you will need a laptop with an Ethernet port and a RJ-45 crossover cable. To connect to the repeater remotely,
you will need to have an active internet connection and the repeater must have either an internal modem or an Omnibox
(ADRF Modem Box) connected to the repeater.
4.1 Repeater/PC Connection Using Web-GUI
A. Verify that your Local Area Connection is set to Obtain an IP address automatically under the Internet Protocol
(TCP/IP) properties
 If you are connecting to the unit remotely (use of a modem), then skip steps A and B.
B. Connect the RJ-45 crossover cable between the laptop’s Ethernet port and the repeater’s Ethernet port
C. Launch an Internet Browser
D. Type the following IP address into the address bar of Microsoft Internet Explorer: http://192.168.63.1
 If you are connecting to the unit remotely, then type the IP address of the modem to connect to the unit
E. The following login screen will appear:
If you are not the Administrator, please type in your assigned username & password which you should have
received from the Administrator.
The default username and password for the General User is adrf & adrf, respectively
And the Administrator User is admin & admin, respectively