User`s manual

ACTIVATE VOX TRANSMISSION
OPERATION
If you congured to an appropriate VOX gain
level, and activate VOX transmission, perform
the following steps.
■ Turn OFF power
■ Press and hold [PTT] switch and then turn
ON power.
■ A double-beep sounds, and then release the
[PTT] switch, the two-way radio sounds the
current channel number.
■ Press [PTT] switch to cancel VOX transmis-
sion, and press [PTT] switch to go on transmit.
Note: A VOX headset is required for VOX
operation.
QT(50 GROUPS) / DQT (107 GROUPS
POSITIVE AND NEGATIVE POSITION)
■ The sellers or manufacturers can use the
programmable software to set QT or DQT
code. When a channel set QT or DQT code,
the squelch function can be used only when
receiving the same QT or DQT signal. Similarly,
only when the QT/DQT signal mode is same as
yours, the radio station can receiver the signal
you transmit. If others use difference QT/DQT
at the same channel from yours to make a call,
the squelch function can’t work and it only has
yellow light indicates.
Note: the way to set QT or DQT refers to the
programmable software.
POWER SAVING FUNCTION:
Power saving: after turning on the two-way
radio for ten seconds and not receiving any
signals or operations, it will automatically be in
the power saving mode.
VOICE ANNUNCIATION
Turning on the two-way radio or rotating the
channel selector, the two-way radio has the
voice annunciation.
8. BASIC OPERATIONS