User`s manual

9. BASIC OPERATIONS
CLONE
Step 1: Verify the Master radio is properly
programmed.
Step 2: With the Master radio powered off,
select channel 8.
Step 3: Press and hold the monitor button
down then press and hold the power on button.
Power on tones are heard followed by a single
beep in the Master radio speaker. Do not
release the monitor and power on buttons until
the single beep is heard. After releasing the
monitor and power on buttons, verify the Master
radio indicator is a steady orange color.
Step 4: Plug one end of the clone cable into
the accessory jack of the Master radio. The
Master radio is now ready to clone.
Step 5: Power on the Slave radio by pressing
the power on button until the power on tones
are heard in the radio speaker. The Slave radio
indicator will occasionally ash green.
Step 6: Plug the other end of the clone cable
into the Slave radio accessory jack.
Step 7: On the Master radio press the power
on button. The Master radio indicator will begin
to ash orange and the Slave radio indicator will
ash green.
Step 8: When cloning is completed, the
Master radio will be a steady orange color and
the Slave radio indicator will occasionally ash
green. Unplug the clone cable from the Slave
radio. Verify the Slave radio has the cloned
program.
Step 9: To clone another Slave radio, repeat
Steps 5 thru 8. To end the cloning procedure,
remove the battery from the Master radio.