User's Manual

Version: 1, Issue Date: July 20, 2007 Page 9 of 10
SPECIFICATIONS
Operation frequency: 450-470 MHz
Channels: 16 Max. (setting by PC programming)
CTCSS/DCS codes: 38 CTCSS/ 83 DCS
Modulation: FM (Narrow/Wide deviation)
Sensitivity: -119 dBm ( -6 dBuV emf)
Noise Squech: Auto (setting by PC programming)
Audio output power: > 100 mW
Audio distortion: < 7 %
Rx signal to noise ratio: > 30 dB
Tx RF output power: 1W (Hi) / 400mW (Low)
Current drain while Receiving: < 150 mA
Current drain while Transmitting: < 1.2A (Hi) / 800 mA (Low)
Current drain at Standby saving on/off: < 20/50 mA
Charge current: 450 mA
Power supply: 4.2V / 1050mAH Li-ion battery
Low voltage indication: 2.8 ~ 3.2 V
Dimensions (HxWxD): 115x53x29 mm (4.5x2.1x1.1 inch)
Weight (without batteries): 100 grams (2.5 oz)
About AWC
AWC Information
Warranty information
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
FCC Requirement
Your radio must be properly licensed by the Federal Communications Commission prior to use. Your dealer
can assist you in meeting these requirements. Your dealer will program each radio with your authorized
frequencies, signaling codes, etc., and will be there to meet your communications needs as your system
expands
.