Installation Guide

10
INSTALLATION
Insert an expansion
bolt set into each of
the drilled bracket
holes.
Leave the hex bolt
head outside of the
hole.
Tighten the hex bolt
head.
Unscrew and remove
only the hex bolt.
Leave the expansion
sleeve inside the hole.
Place the wall bracket
over the holes and
use a level to make
sure the bracket is
straight.
Re-insert the hex
bolts into the holes
through the wall
bracket.
Tighten the hex bolts
to secure wall bracket
to surface.
CAUTION: Do not over
tighten.
Fig 21
Fig 23 Fig 24
Fig 26
Fig 22
Fig 25
Toll Free (US): [phone] www.advaning.com
Tighten
Socket
wrench
BracketBracket
Level
Expansion bolt set
Hex bolt
Hex bolt
Tighten bolt head
Leave hex bolt
head outside
Wall
Wall
Wall
Wall
Bracket
6
7
8
9
10
11
12
6
7
8
9
10
11
12