Instruction manual

Maximum Series Portable Chiller : Air & Water-Cooled : M1 Series Instrument
Page: 59
ADVANTAGE ENGINEERING, INC.
525 East Stop 18 Road Greenwood, Indiana 46142
317-887-0729 Fax: [phone]
Service Department Fax: [phone]
Email: [e-mail]
6.3 UNIT OPTIONS
A. LOW FLOW BYPASS: If your
process will experience lower than
designowratesorintermittent
ow,alowowbypassvalvewillbe
required.
B. OVERHEAD PIPING KIT: To avoid
reservoiroverowduringshut
down periods from overhead
piping, Advantage recommends the
installation of an overhead piping kit.
The overhead piping kit consists of
a full line size solenoid valve in the
“from process” line that is interlocked
with the pump and a check valve
(single direction valve) in the “to
process” line.
C. PROCESS LINE SHUT OFF
VALVES: These valves are full size
ball valves installed on the “to” and
“from” process lines at the exit of the
chiller. These valves can be used to
adjusttheprocessowrateandto
shutofftheowratetoisolatethe
chiller.
D. E-STOP BUTTON: The Emergency
stop button is a mushroom type
button which will shut down all chiller
operations when engaged.
E. NON-FUSED OR FUSED
DISCONNECT SWITCH: On
board disconnect switch provides a
convenient location for isolating all
electric power to the chiller.
F. AUDIBLE AND OR VISUAL
ALARM: Alarms indicate out-of-spec
operating conditions. There are two
types of alarms:
Audible Alarm: A simple buzzer
alarm emits a loud alarm.
Visual Alarm: Emits an audible
soundandashesabeacon.
Typical optional automatic low
owbypassvalve.
Typical overhead piping kit. Shown
with optional process line shut off
valves. Process line shut off valves
are also shown in this photo.
Emergency stop button. Shown
with Power On light.
Non-fused disconnect show.
Typical Alarm Beacon.