User`s guide

A-61520 April 2005 5
Using the TWAIN
Datasource
The TWAIN Datasource is a piece of software that communicates with
your scanner. It is provided by Kodak with the i200 Series Scanners.
Many scanning applications support the TWAIN standard and this
datasource can be used to interface with these applications.
This section provides descriptions of the scanner features using options
on the TWAIN tabs and how to set these options. If you are using the
TWAIN Datasource, follow the procedures in this section to set up your
scanner. If you are using the ISIS Driver, see the section entitled,
“Using the ISIS Driver” later in this document.
For the purpose of this manual, all displayed dialog boxes assume the
features available on the Kodak i260 and i280 Scanners (duplex
scanners). If you have a Kodak i250 Scanner (simplex scanner) all
options are limited to simplex scanning only.
Kodak Scanner
Properties dialog box
The Kodak Scanner Properties dialog box allows you to review and
configure the scanner’s settings. It consists of several tabbed windows
each of which will be described within this chapter.
Click on each tab to set all the desired values. You do not have to click
OK until you have made all selections on all of the tabs.
Buttons on the Kodak
Scanner Properties dialog
box
Following are descriptions of the buttons located at the bottom of the
dialog box.
Defaults  when you select Defaults, the message Reset all values
to factory defaults? will be shown. Clicking Yes on this message will
reset all values on all tabs to the factory default settings.