Specifications

Chapter 2 Installation 7
Figure 2-2 ADAM-6541-Rear Panel
2.2 Full / Half-Duplex Selection
There are two modes of data transmissions, full-duplex and half-duplex trans-
mission. The data can be transmitted in both directions on a single carrier at
the same time when you select Full-duplex mode. But the data can only be
transmitted in one direction on a single carrier at the same time when you
select Half-duplex mode. You may select Full or half-duplex mode according to
your equipment requirement.
You can configure full or half-duplex ADAM-6541 via JP1 (located on the
top-left PCB.)
JP1 Description
Half-Duplex
Full-Duplex (Default)
NOTE: Fiber Transmission Distance
(1) Half duplex: 412 m
(2) Full duplex: 2 km