User Manual

16. Make sure the user does not allow contact between
SIP/SOPs and the patient at the same time.
17. Follow national, state or local requirements to
dispose of unit.
18. Maintenance: to properly maintain and clean the
surfaces, use only the approved products or clean
with a dry applicator.
19. Contact information:
No.1, Alley 20, Lane 26, Rueiguang Road
Neihu District, Taipei, Taiwan 114,
R.O.C.
TEL: [phone]
20. This equipment shall not be used as a life support
system.
21. Use a power cord that matches the voltage of the
power outlet, which has been approved and
complies with the safety standard of your
particular country.
22. Do not place the power cord where it is difficult to
disconnect and may be stepped by other person
Environmental protection.
Follow national requirements to
dispose of unit.
23. “WARNING - Do not modify this equipment
without authorization of the manufacturer.”
24. “WARNING – To avoid risk of electric shock, this
equipment must only be connected to a supply
mains with protective earth.
25. “CAUTION: This adapter Tamura / XAIM-
XEW1934N-5158 is a forming part of the device.”
26. Remove the power cord to fully turn off the device
when the battery pack is empty.
27. Classification:
1). Class I
2). No applied part
3). Continuous Operation
28. CAUTION! This product: AIM-78S is used with the
Qualified & certificated power adapter: Tamura /
XAIM-XEW1934N-5158. Output: Output: 19Vdc,
3.43A max
29. DISCLAIMER: This set of instructions is given
according to IEC 704-1. Advantech disclaims all
responsibility for the accuracy of any statements
contained herein.
30. In case of serious incident that has occurred,
please contact the manufacturer and local
authorities immediately.
Notice: It is recommended to install the
appropriate soft if have any question, please
contact the manufacturer for further assistance.
Notice: To prevent unauthorized access, it is
recommended to install suitable anti-virus
software or do not connect to unsafe external
networks
Complies with FDA performance standards for laser
products except for deviations pursuant to Laser
Notice No. 50, dated (Insert date of this guidance.)
IEC 60825:2007
Caution - Use of controls or adjustments or performance
of procedures other than those specified herein may
result in hazardous radiation exposure
Attention - L'utilisation des commandes ou réglages ou
l'exécution des procédures autres que celles
spécifiées dans les presents exigences peuvent être
la cause d'une exposition à un rayonnement
dangereux
Explanation of Graphical
Symbols
IEC 60878 and ISO 3864-B.3.6 :
Warning dangerous voltage.
ISO 7000-0434 : Caution, consult
ACCOMPANYING DOCUMENTS.
ISO 7000-1641 : Follow operating
instructions or consult instructions for
use.
IEC 60417-5009 : STAND-BY.
IEC 60417-5032 : Alternating Current.
IEC 60417-5031 : Direct Current.
Tablet Specifications