User`s manual

AIMB-240 Series
70 AIMB-240 Series User’s Manual
Item Options Description
Onboard FDC Controller
Enabled
Disabled
Select Enabled if your system has a floppy disk
controller (FDC) installed on the system board
and you wish to use it. If you are not going to
use FDC or the system has no floppy drive,
select Disabled in this field.
Onboard Serial Port 1
Onboard Serial Port 2
Disable, 3F8/IRQ4
2F8/IRQ3, 3E8/IRQ4
2E8/IRQ3, AUTO
Select an address and corresponding interrupt
for the first and second serial ports.
UART Mode Select
IrDA
ASKIR
Normal
IrDA/UART function select
RxD , TxD Active
Hi,Hi
Hi,Lo
Lo,Hi
Lo,Lo
This setting the Hardward IrDA signal’s Logic
Level
IR Transmission Delay
Enabled
Disabled
Enabled/disabled IR Transmission Delay
UR2 Duplex Mode
Full
Half
Full duplex/ half duplex mode select
Use IR Pins
RxD2,TxD2
IR-Rx2Tx2
IR I/O pins’ location select
Onboard Parallel Port
Disabled, 378/IRQ7
278/IRQ5, 3BC/IRQ7
Select a matching address and interrupt for the
physical parallel (printer) port.
Parallel Port Mode
SPP, EPP
ECP, Normal
ECP+EPP
Select an operating mode for the onboard
parallel port. Select Compatible or Extended
unless you are certain both your hardware and
software support EPP or ECP mode.
EPP Mode Select EPP1.9, EPP1.7 Select EPP port type 1.7 or 1.9.
ECP Mode Use DMA 1, 3 Select a DMA channel for the port.
PWRON After PWR-Fail
Off, On
Former-Sts
This item is to set whether to run Ac Loss Auto
Restart or off
Onboard Serial Port 3
Onboard Serial Port 4
Disable, 3F8
2F8, 3E8,
2E8
Select an IRQ address for the third and forth
serial Ports.
Serial Port 3 Use IRQ
Serial Port 4 Use IRQ
IRQ3, IRQ4, IRQ5
IRQ9, IRQ10, IRQ11
Select an IRQ for the third and forth serial
ports.
Serial Port 3 Mode Normal
IRDA
Select an IO address for the third serial ports
Item Options Description
Onboard Serial Port 3
Onboard Serial Port 4
Disable, 3F8
2F8, 3E8
2E8
Select an address for the serial ports 3 and
serial ports 4.
Serial Port 3 use IRQ IRQ3,IRQ4 Select an corresponding interrupt for the Serial