User manual

ManualsBrandsAdvantech ManualsComputer equipmentAIMB-556

AIMB-556 User Manual 18

Chapter 2 Connecting Peripherals

2.1 Introduction

You can access most of the connectors from the top of the board as it is

being installed in the chassis. If you have a number of cards installed, you

may need to partially remove the card to make all the connections.

2.2 Primary (IDE1) IDE Connector

You can attach up to four IDE (Integrated Drive Electronics) drives to the

AIMB-556’s built-in controller. The primary (IDE1) connector can each

accommodate two drives.

Wire number 1 on the cable is red or blue and the other wires are gray.

Connect one end to connector IDE1 on the motherboard. Make sure that

the red/blue wire corresponds to pin 1 on the connector (in the upper right

hand corner). See Chapter 1 for help finding the connector.

LAN1_US

B12

LAN

1_USB12

LAN2_USB34

AUDIO1

KBMS1

VGA2

CN1

SPI_CN1

JSETCOM2

CN2

JCASE1

SP1

1 2 3 4 5 6 7 8 9

U22

PSON1

LPT1

COM1

VGA1

CPU1

CN22

BAT1

CHAFAN2

CPUFAN1

SYSFAN1

SPI_CS_CN1

J16

CMOS1

JWDT1

ATX1

VP1

JIR1

HS1

HD1

COM3

COM4

COM2

LANLED1

MH7

MH8

MH5

MH4

MH2

MH1

MH3

SATA2

SATA1

B78

USB56

ATX2

FDD1

IDE1

LVDS1

PCIEX-4X1

PCI1

PCI2

PCIE-16X1

DIMMB1

DIMMA1

U14

Update Second SPI:2-3 Close

Update First SPI:1-2 Close

ATX MODE:2-3 Close

AT MODE:1-2 Close

19C2055603

MADE IN TAIWAN

01-4

AIMB-556 REV:A1

LED1

PCIE_SW1

JFP1

JFP2

JFP3

LED2

SATA3

IDE1