User manual

7 ACP-2010MB User Manual

Chapter 2 System Setup

2.2 Installing the Motherboard

The ACP-2010MB can support an ATX / MicroATX motherboard with up to three add-

on cards via the expanded riser card, or seven low profile add-on cards via the

optional special rear I/O bracket.

To install the motherboard, please proceed as follows:

1. Remove the card holder by loosening the two screws.

2. A yellow label is located inside of the chassis bottom. (see Figure 2.2) The label

shows the plastic post locations for attaching specific Advantech motherboards.

Figure 2.2 Yellow label indicating plastic post locations

3. Users can find the plastic post in the accessory box. Insert the plastic post to the

correct location and then rotate counterclockwise to fasten it onto the chassis

(see Figure 2.3).

4. Attach the motherboard I/O shielding onto the rear plate first. Then fasten the

motherboard onto the chassis (see Figure 2.4).

5. If you don't need to install a riser card and an add-on card, return the card

holder to its original position and fasten it.

6. Connect the 20-pin (or 24-pin) ATX power connector and the 4-pin +12 V power

connector from the power supply to the motherboard

7. Connect the 9-pin USB wire, PS/2 wire, Power switch wire, and the System

Reset switch wire from the chassis to the motherboard.

Note! Use caution when installing a motherboard. We highly recommend

choosing a CPU cooler which is lower than 67 mm to avoid component

interference between the motherboard and the chassis, and to ensure

good air flow inside the chassis.

ATX motherboard

Special:

AIMB-744

Model

Mark

AIMB-750

AIMB-760

MicroATX motherboard

The plastic post is in the

accessory box. Be sure to

attach the post onto the

correct location.